HF Antenna for ARS WB6PIH and ARS WØPE
HF6V Antenna
This project started after the City of Yorba Linda sent a notice that after 18 years my Hy-Tower vertical must be removed. So to put something up that did not require a conditional use permit that would be a minimum of about a thousand dollars and no guarantee that I would get it. I made the decision to put up something that would meet their section A part of their ordinance. Something that is under 42 foot tall. Also that is 25 foot back from the rear property line. After a lot of looking and reading about different vertical antennas I picked the Butternut HF6V.
The assembly of the antenna is not bad if you follow the instructions. Does take a while to figure out how to assemble a couple of things. Also I did up grade a couple of things. Changed out pop rivets to real stainless hardware.
I did add a couple of things to the antenna. 1st I added a DX Engineering Stainless Steel Radial Plate DXE-RADP-1P. Also I added a 1 inch stainless steel pipe to mount the antenna base on. 2nd added a DX Engineering Feedline Current Choke DXE-FCC050-H05-A .
I mounted 60 1 inch 1/4-20 bolts on to the radial plate. I used an anti-seize on the bolt, lock washers, and nut. Also added a couple of 1/4-20 bolts for the ground straps.
I worked on it as I had time. Took about 8 weeks to do this. I would guess total man hours were around 65 to 70 hours.
Didn't get all 60 radials in got about 50 in place.
The white fence around it is all PVC to keep grand kids and a tortoise out of the coils.
(Click on the picture to enlarge)
Stainless Steel Radial Plate
To mount the plate and main support piece I added a 1 inch piece of stainless pipe.
Support base before being slid down the stainless pipe.
Support piece in place.
With plate.
Conduit run for feedline
Installing the radials.
The radials in the lawn.
FCC Cover
Weed Guard
Weed Plate
Helpers
Weed Plate in place
Feedline Current Choke
Done
Most Helpful information
BigIR Mark III Installation ARS AE1Z
Andrey Stoev AE1Z and his site. One the most helpful. The edger he shows saved many man hours of work. Go to his web site and check it out.
List of parts
Butternut HF6V
Feedline Current Choke
Stainless Steel Radial Plate
Stainless 1/4 Bolts, Internal lock washers, nuts
10-32 and 8-32 Stainless Hardware
Bunch of #12 insulated wire
Penetrox A-13
Never-Seez Regular Grade
30 Ft 3/4 PVC Conduit and fittings
Sprinkler Cover
White PVC Fence
PL259 Connectors